Two size ranges are available to suit beam widths, the size A range isfor smaller beams up to 220mm and type B for beams up to 300mm wide.

Key Features of the Yale HTP Push travel Trolley

• Easy to manually push & pull along the beam.
• steel wheels.
• Ball bearings pre-lubricated and encased for smooth operation.
• Central clevis bar for easy adjustment to suit the beam size.
• No creeping to either side.
• Wheels are designed for a beam profile incline of 14%.
• UVV and machinery directives met.

About the HTP Push Travel Beam Trolley

Fitting the trolley to a beam is relatively straightforward; you should allow between 1.0 & 2.5mm gaps between the wheel and beam flanges for optimum safety. There are three main components to the trolley for fitting, the clevis load bar, and two side plates which include the wheels.

Screw the adjusting load bar into the side plates one at a time until the bar just protrudes from the outer side. Additional spring washers and cylinder screws are needed for the type B trolleys (included).

Using the screw load pin, adjust the width to fit over the beam flange, when in position you can tighten up the side plates until the trolley fits correctly with the wheels in contact and with the correct spacing as stated above.

The load bar has a central lifting eye from where to fit your hoisting device, this must always be in the vertical position, never horizontal.

Extra Info & Ordering

If you require an ATEX rated model (see specifications for full details) please give us a call or drop us an email for a quotation. Please note the bronze wheels are only on the high rated models, the basic models have an MKS  micro corrosion protective coating.

 You can find the technical details in the table below. If you need additional information on any beam trolley you can contact the team on 01384 76961. When you are ready you can add to cart to make an online purchase.